No-purge device provides comparable, formation quality samples of ALL parameters from small-diameter (1.5" and larger) wells for both short and long-term monitoring.
The armored HydraSleeves have a protective outer sleeve that more than doubles the wall thickness.
An Armored HydraSleeve could be useful in steel wells, open boreholes, or anywhere you might expect that a HydraSleeve would come in contact with jagged edges or increased potential for abrasion.
Disposable. Fits in 1.5 Schedule 40 and larger wells. Standard material = virgin 7 mil PE.
Absolute maximum volume obtainable without spilling 500 mls
LAYFLAT | FILLED | FILLED | FILL | |
WIDTH | LENGTH | DIAMETER | VOLUME | STROKE |
2.5" | 30" | 1.5" | ~500 ml | 30" |
Fill stroke is the length of the sampler when used in 1.5-inch to 2-inch wells. It will be longer for larger diameter wells. Alternative method of recovery is recommended for use in larger wells - see link below.
DO NOT USE SPRING CLIPS WHERE JAGGED EDGES AND OBSTACLES ARE APPEARANT DOWNHOLE - Therefore you typically will not use spring clips with armored versions of the HydraSleeve.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
REQUIRED/RELATED ACCESSORIES |
DETAILS | ARTICLES OF INTEREST RELATED TO THIS PRODUCT |
General information on Armored HydraSleeve | Armored HydraSleeves | |
Minimum Recommended Weight 8-ounce bottom weight |
If the well is more than 250 feet deep, or there are obstacles down hole, you may want to use heavier than 8 ounces. Also stringing multiple sleeves on one tether requires heavier weight. |
Weight Selection Chart |
Top Weights cannot be used with armored HydraSleeves |
If you encounter short saturated screens and need to use armored sleeves we recommend using an alterntive method of recovery - see link >>>> |
Alternative method of recovery - oscillating HydraSleeves during retrieval |
Tether available in 500, 1000, and 2000-foot rolls. Marked sequentially in feet along the length of the line. |
About our tether. | |
Sand Weight Clips - for attaching the bottom of HydraSleeves to the tether. Typical for multiple sleeve deployment. |
About bottom (sand weight) clips | |
Spring Clips are not typically used with Armored HydraSleeves |
Don't use Spring Clips in 1.5" wells or when there are obstacles |
Alternative Attachment without spring clips |