(GSH230) Standard 4-inch HydraSleeve 2.5 liter

4-inch HydraSleeve made to hold greater than 2.5 liters of sample volume. For 4-inch diameter (and larger) wells.

Standard 4-inch HydraSleeve ~2.5 Liter Sample Volume

Sales price $40.00

Total: $40.00

Description

4-inch HydraSleeve made to hold greater than 2.5 liters of sample volume.

2.9 inches O.D. by 37 inches long. Fill within a 7-foot column. Lay-flat width 4.614 inches.

Absolute maximum volume obtainable without spilling 3.1 liters

LAYFLAT		FILLED	FILLED	FILL
WIDTH	LENGTH	DIAMETER	VOLUME	STROKE
4.61"	37"	2.9"	~3000 ml	37"

Fill stroke is the length of the sampler when used in 4-inch wells. It will be longer for larger diameter wells. Alternative method of recovery is recommended for use in larger wells - see link below.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

REQUIRED/RELATED ACCESSORIES	DETAILS	ARTICLES OF INTEREST RELATED TO THIS PRODUCT
Recommended Top Clip: 4-inch Spring Clip	Don't use Spring Clips in wire wrap wells or where there are obstacles.	Spring Clip Instructions Alternative Attachment without spring clips Spring Clip Basics
Recommended Minimum 11-ounce bottom weight	If the well is more than 250 feet deep, or there are obstacles down hole, you may want to a heavier weight. Also stringing multiple sleeves on one tether requires heavier weight.	Weight Selection Chart
Optional 4-inch PVC Top Weight	Top weights would be needed for short water columns - less than 6 feet.	Topic of Top Weights Alternative method of recovery - oscillating HydraSleeves during retrieval
Tether available in 500, 1000, and 2000-foot rolls. Marked sequentially in feet along the length of the line.	Any type of cable or line can be used.	About our tether.
Sand Weight Clips - for attaching the bottom of HydraSleeves to the tether. Typical for multiple sleeve deployment.		About bottom (sand weight) clips
		How to shorten HydraSleeves for less sample volume