Two-piece, 64 ounce, top weight for use with the 4-liter TurboSleeve SuperSleeve. Top section is PVC and the bottom is stainless steel.
They thread together holding the TurboSleeve in place. This is a reusable item. The weight includes a spring clip for attaching the tether line. Should be used in conjunction with a 5-ounce bottom weight, when deploying the TurboSleeves.
TOTAL LENGTH: 20 INCHES
STAINLESS LENGTH 18 INCHES
WEIGHT 3.9 POUNDS
OD: 1.9 INCHES (FITS INSIDE 2-INCH SCHED 40 WELL & LARGER)
Please leave at least 8 feet of slack in the tether line for the TurboSleeve to compress into the bottom of the well. A minimum of 36 hours should be left for equilibration time due to the amount of mixing in short water columns when placing these TurboSleeves in the well.
The TurboSleeve weight is on the right side of this photo. As you can see the TurboSleeve assembly may be a bit difficult to handle. There are also special precautions to be considered before using the extra-long TurboSleeve. Please see the instructions linked here.